Hoppe Fuhr Multi-Point Lock, 3 Hooks, 35MM - 6-8 Sliding Door
Face Plate Measurements: 5/8 Wide x 64-5/8 inches long.
Hooks: three hooks, two below the handle, one above.
Bottom Hooks Located: 8-1/2 & 24-1/4 inches from the tip of the hook to the center of the handle.
Top Hook: 20 inches from the tip of hook to center of handle, When door is in unlocked position.
There is a top section (not included) that locks into the main body to allow for different door heights
Lock Body Measurements:
Backset: 1-3/8 inches - measured from the edge of lock to center of handle
Handle / Key Spacing: 4-3/4 inches - distance from the center of spindle to center of key (cylinder will not operate when in unlocked position)
Sticker on some locks: U2/KOP
After many years of putting off replacing my old door locks which barely worked when new I finally ordered from Countryside. The new parts arrived on time and fit and work perfectly. Years of frustration could have been avoided had I found Countryside earlier.
My sliding glass door is over 15 years old, and the lock has been a bit problematic for the past few years. It finally became annoying to the point that a replacement seemed necessary. This newer version dropped right in, and works seemingly better than the original did when new. Highly recommended so far. Thanks!
HOPPE FUHR MULTI-POINT LOCK, 3 HOOKS, 35MM - 6-8 SLIDING DOOR
All areas of lock locations and measurements were displayed very well, and enabled me to feel confident in the purchase, without reservation.👍🏻
My old Hope multi-point sliding door lockset was hopelessly broken. My local locksmith warned me that it would be difficult finding parts and they would be extremely expensive. Fortunately I found Countryside Locks. The replacement Hoppe Fuhr lock was an exact fit and I installed it in a few minutes. The new lock functions much better than the original ever did. Sorry I didn’t replace it 15 years ago.